Timing: the budget, practice time, and what a check costs
Reference

Timing: the budget, practice time, and what a check costs

Three calculators. Whether your run sheet fits the minutes you have, how long one person actually gets at a station, and what the checks cost before you put them on the sheet.

Three calculators, all arithmetic on figures you enter. Nothing on this page recommends a length, a buffer or a number of attempts, because no source in our resource library publishes one. Where a default does exist, it comes from a published protocol and says so.

1. Session budget

Answers: whether your run sheet fits, and how many minutes are left for the teaching segments once the practice, the checks and a buffer are taken out. Used in Workshop timing: minutes on paper and minutes in the room and Structuring a session: the run sheet. Take the minutes per practice block from calculator 2 and the minutes per check from calculator 3.

Assumptions behind the numbers

  • Arithmetic on figures you enter. Nothing here recommends a length.
  • The buffer has no default and starts at zero. No source in our resource library gives a correct buffer for a teaching session; it is your own choice about how much of the session you are willing to leave unplanned.
  • There is no default segment length either. The one widely published convention, one training company's 90-20-10 rule, carries no source on the page that publishes it, and the ten-to-fifteen-minute attention claim behind most others was traced by a peer-reviewed review and found unsupported. Both are set out in Learning myths and other claims about teaching, and what their sources say.
  • Minutes per practice block and minutes per check are yours to enter. The two calculators below produce figures you can put in them.
  • Buffer minutes come off the total before anything is allotted, so the minutes per segment shown already allow for it.

2. Practice time per person

Answers: how many minutes one person actually gets on the work, how many people are waiting at any moment, and how long a block would have to be for the attempt length you want. Used in Designing the part where they do it. The last field is optional: set it to the attempt length you think the task needs and the calculator tells you whether the block covers it.

Assumptions behind the numbers

  • Every station is in use for the whole block, and people change over in the time you entered. Both are optimistic; a real block loses minutes to instructions and to the first person being unsure.
  • Attempts each has no default. No source in our resource library gives a correct number of repetitions for an arbitrary skill, and a default in a calculator reads as a recommendation. The evidence that does exist is about practice needing a target and feedback, and about spacing attempts, which Designing the part where they do it sets out.
  • "Waiting at any moment" is participants minus stations. It is the number that decides whether the waiting people need a job, and they do.
  • Your own time for one attempt is not the planning figure. A beginner commonly takes two or three times longer on a first attempt, and your own recorded minutes from After the workshop: what happened and what to change are the better source once you have them.

3. What a check costs

Answers: how many minutes one check for understanding takes, start to finish, and what your checks cost in total. Used in Checks for understanding: finding out whether it landed and Workshop timing: minutes on paper and minutes in the room. The defaults here are published figures, named below.

Assumptions behind the numbers

  • The 45 seconds of thinking alone sits inside the published ConcepTest range of 30 seconds to 1 minute for individuals to consider the question and choose an answer (SERC, How to use ConcepTests).
  • The 1.5 minutes of pair discussion sits inside the same protocol's 1 to 2 minutes for discussing reasons with neighbors when the first count falls in the 35 to 70 percent band.
  • The 3 second pause is the floor from the wait-time guidance, which reports that teachers typically wait under one second and recommends 3 to 7 seconds (K. Patricia Cross Academy, Wait for It!). It is the pause, not the thinking time; both are counted.
  • Re-poll and explain starts at zero because we found no published figure for it. Put in your own, and replace it with your recorded minutes after the first run.
  • The protocol comes from undergraduate science teaching. The arithmetic holds for a room of eight; the confidence you can place in a count of eight is lower than in a count of eighty.